KVH Industries TracPhone V7 User Manual download pdf (Page 6)

6

If you plan to mount the control unit and modem

inside the optional 19" (482.6 mm) case, follow

these steps to assemble the case.

a. Remove the four M4 screws securing the rear

cover to the case. Discard the rear cover.

b. Attach the top cover to the case using four

M4 x 12 mm screws (see Figure 6). Attach the

bottom cover and the two mounting brackets

using four M4 x 16 mm screws.

c. Attach the four plastic feet to the bottom

cover (see Figure 6).

d. At the front of the case, insert eight cage nuts

into the following locations on the frame

(four on each side) (see Figure 6): #2, #5, #8,

and #11.

e. At the back of the case, insert four cage nuts

into the following locations on the frame (two

on each side): #1 and #3

f. Remove the four #6-32 screws and washers

securing the two retaining straps to the rear

panel of the control unit. Do not remove the

bottom screws securing the straps to the modem.

g. Attach the strain-relief bracket to the

retaining straps and control unit using the

screws and washers you removed in Step f

(see Figure 7).

h. At the top 3U section of the case, insert the

control unit/modem assembly and secure the

front mounting brackets to the case using

four M6 screws and washers (see Figure 8).

i. At the bottom 3U section of the case, attach

the supplied blank panel using four M6

screws and washers (see Figure 8).

j. Secure the back of the control unit to the back

of the case using the two supplied “Z”

brackets. Attach the brackets to the case

frame using four M6 screws and washers.

Attach the brackets to the rear panel of the

control unit using four #6-32 screws and

washers (see Figure 8).

k. Once you have completed all system wiring,

mount the case to the vessel using fasteners

appropriate for the mounting surface.

M4 x 16mm Screw (x4)

Mounting Bracket (x2)

Top Cover

Bottom Cover

M4 x 12mm Screw (x4)

Plastic Foot (x4)

1

2

3

4

5

6

7

8

9

10

11

12

Figure 6: Assembling the Case

#6 Washer (x4)

#6-32 Screw (x4)

Strain-Relief

Bracket

Tie-Wrap

Holes (x12)

Retaining

Strap (x2)

Control Unit

Modem

Figure 7: Attaching the Strain-Relief Bracket

M6 Screw (x4)

Plastic Washer (x4)

#6 Washer (x4)

#6-32 Screw (x4)

“Z” Bracket (x2)

Cage Nut (x4)

Attach to Case

Attach to Control Uni

t

M6 Screw

(

x8

)

Plastic Washer (x8)

Cage Nut (x8)

Blank Panel

Control Unit

and Modem

Case

Figure 8: Securing the Control Unit/Modem in the Case

Prepare the Belowdecks Units

4

Option 1 - Mounting in the Case

1 2 3 4 5 6 7 8 9 10 11 ... 29 30

Comments to this Manuals

No comments