KVH Industries antenna system User Manual Page 83

  • Download
  • Add to my manuals
  • Print
  • Page
    / 111
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 82
54-0287
9.4
TracVision Receiver User’s Guide
9-1 Causes and Remedies for
Common Operational Issues
There are a number of common issues that can affect
the signal reception quality or the operation of the
TracVision system. The following sections identify
these issues and provide potential solutions.
Receiver Power Switch Turned Off
Your TracVision receiver’s rear panel power switch
(see below) must remain on for the system to work. If
the system is entirely non-functional, check the switch
to ensure that it is turned on. The switch illuminates
green when turned on.
Blown Fuse
The receiver’s power input cable includes an in-line
fast-blow fuse, rated for 6 amps, located on the end of
the cable nearest the receiver. If this fuse has blown,
the system will not operate. Unscrew the cap on the
fuse holder and replace the fuse. If you replace the
fuse, but it blows again, check the receiver to ensure
that it is clear of debris and the connectors are tight.
Do not replace the fuse with a larger amperage fuse.
Receiver Power Switch
CAUTION
POWER
VEHICLE POWER
(10-16 VDC)
VHF ANTENNA
IN
AUDIO R AUDIO L VIDEO
S – VIDEO
PHONE JACK
RF
REMOTE
INPUT
OUT TO TV
TUNER
SATELLITE IN
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device must not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Tested to comply
with FCC Standards
TO SATELLITE
IN
TO KVH
ANTENNA
DIAGNOSTICS
PORT 1
DIAGNOSTICS
PORT 2
Power Switch
If the TracVision system is not working
properly, try resetting the system before
you begin troubleshooting. To reset,
follow the simple steps below.
1. Stop in a blockage-free area.
2. Turn off the receiver’s rear panel power
switch.
3. Turn the receiver’s rear panel power
switch back on.
4. If the TracVision antenna is turned off,
turn it on (press SAT then PWR).
5. Wait one minute for the antenna to
acquire the satellite.
Page view 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 110 111

Comments to this Manuals

No comments