KVH Industries TracVision 4 User Manual download pdf (Page 50)

5.8 Preparation for Shipment

If it is necessary to repack the Antenna Unit for shipment, the

shipping restraint removed during installation must be replaced.

Follow these steps to reinstall the restraint.

1. Rotate the azimuth mechanism slowly to find the

limit switch stop. The front of the antenna should

be facing the forward arrow.

2. Rotate the azimuth mechanism 180˚ in the

opposite direction to ensure that the mechanism is

not resting on the limit switch stop.

3. Pivot the reflector edge to its lowest position as

shown in Figure 5-10.

4. Place the foam shipping restraint, label side up,

between the reflector and the azimuth motor, as

illustrated in Figure 5-10. The reflector should now

be captured behind the restraint.

5. Pack the TracVision 4 unit in its original package.

6. As detailed in the warranty accompanying this

product and printed on the last page of this

manual, a Return Material Authorization (RMA)

number is required prior to the return of the

TracVision 4 system to KVH. Contact the KVH

Technical Support Department at +1 401 847-3327

or via email at [email protected] to obtain the RMA

number. Please review your warranty to

familiarize yourself with all requirements,

liabilities, and policies.

5-11

Maintenance

54-0150 Rev. D

When rotating the azimuth

mechanism by hand, go slowly!

Hitting the mechanical stops with

excessive force will damage the

azimuth limit switch.

Foam

Shipping

Restraint

Figure 5-10

Shipping Restraint Placement

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 72 73

No comments

KVH Industries TracVision 4 User Manual Page 50