KVH Industries TracVision S3 User Manual download pdf (Page 59)

5.5 Preparation for Shipment

If it is necessary to repack the antenna unit for shipment, the

shipping restraints removed during installation must be

replaced. Follow these steps to reinstall the restraints.

1. Remove the radome.

2. Rotate the antenna unit so that the LNB is facing

away from the baseplate connectors.

3. Attach the three restraints to the baseplate using

the

⁄4"-20 x

⁄8" hex screws and washers (provided in

the kitpack) and nuts (removed from the restraints

during installation) as pictured in Figure 5-8.

4. Place the antenna bracket on the forward shipping

restraint.

5. Secure the forward restraint and bracket by

wrapping two tie-wraps around the bend in the

forward restraint and the antenna bracket (at the

end of the LNB bracket).

6. Replace the radome.

7. Place the entire antenna unit into its shipping box

using the original packaging material. Secure the

box to a pallet to ensure upright transport to KVH.

5-9

Maintenance

54-0157 Rev. G

When rotating the azimuth

mechanism by hand, go slowly!

Hitting the mechanical stops with

excessive force will damage the

azimuth limit switch.

Figure 5-8

Attaching the Shipping Restraints

to the Antenna Baseplate

Figure 5-9

Securing the Forward Shipping

Restraint

KVH is not liable for damage

caused by improper shipping.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 76 77

No comments

KVH Industries TracVision S3 User Manual Page 59