KVH Industries TracVision S3 User Manual download pdf (Page 71)

Analog Signal Strength Report

Function: reports signal strength from RF detector circuit in

A/D counts (000-FFF Hex)

Command: SIGLEVEL

Argument: none

Response: Signal Strength = xxxx

E.5 RF Board Commands

Serial Communications, Status/Polarization Report, Tone Changes

Function: start serial communications, reports status &

polarization/tone changes

Command: @S

Response: S,s,p,b,m <cr> every 5 seconds until ><cr>is

returned from system software

Where: s = Satellite (a = Primary, b = Secondary)

p = Polarization (v = Vertical, h = Horizontal,

r = Right, l = Left, x = No LNB Power)

b = Band (h = High Band, l = Low band, u = USA)

m = Mode (v = Valid, i = Invalid)*

* The Mode bit is used to evaluate the Satellite, Polarization, & Band

combination vs. the Frequency/Symbol Rate/FEC currently in RAM. This bit will

be set to invalid if the Frequency for the selected combination is set to 0x0000;

otherwise it will be set to valid.

E-5

Maintenance Port Parser Commands

54-0157 Rev. G

Table E-5

RF Board Commands

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 77

No comments

KVH Industries TracVision S3 User Manual Page 71