KVH Industries antenna system User Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 111
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
54-0287
2.6
TracVision Receiver User’s Guide
2-5 How the System Works
This section explains how the system starts up and
how the antenna turns on and off. You do not need to
read this section to operate the system. It is provided
for information only.
System Startup
Whenever you apply power to the TracVision
receiver, the system automatically starts up,
regardless of whether the antenna was last turned on
or off.
1. The receiver powers up. The receivers rear panel
power switch must be turned on. Normally, this
switch should remain on at all times.
2. The receiver beeps two or three times and sends
power to the antenna.
3. The antenna powers up and searches for the
satellite signal. You might hear slight mechanical
noise as the antenna’s internal motors operate.
4. The antenna finds and starts tracking the
DIRECTV satellite. The antenna should become
relatively quiet while tracking the satellite.
The system exits the Startup mode after 30 seconds.
Why Does the Receiver Beep?
The receiver beeps to indicate the
status of the antenna.
2 beeps = Antenna is powering on
1 beep = Antenna is powering off
BEEP
BEEP
Power
Antenna ON
System Startup
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 110 111

Comments to this Manuals

No comments