KVH Industries TracVision 6 User Manual download pdf (Page 78)

Maintenance Port Parser Commands

54-0166

Enter Serial Number

Function: enters system serial number

Command: =SERNUM,XXXXXXXX

Where: XXXXXXXX = the system’s serial number

Response: SN = XXXXXXXX

Configure System

Function: configures software for a particular system model

Command: =TVXXXX

Where: XXXX = system model (i.e., G6HP)

Response: system configures software and antenna restarts

E.2 Manual Positioning Commands

To execute the following commands, first put the antenna unit in

idle mode by typing

HALT and pressing “ENTER.” Positioning

commands may be entered after the antenna comes to rest.

Azimuth Angle

Function: commands a manual azimuth angle that the

mechanism moves to

Command: AZ,XXXX (range is 0000-3599)

Argument: desired azimuth angle of the mechanism relative to

external magnetic reference, or baseplate fwd,

000°-359.9°

Response: echoes the command; mechanism moves at a

fixed velocity

Elevation Angle

Function: commands a manual elevation angle that the

mechanism moves to

Command: EL,XXX (range is 100-850)

Argument: desired elevation angle of the mechanism relative to

up, or external sensor attitude reference, 10.0°-

85.0°

Response: echoes the command; mechanism moves at a

fixed velocity

Table E-2

Manual Positioning Commands

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 87 88

No comments

KVH Industries TracVision 6 User Manual Page 78