KVH Industries TracVision G4 User Manual download pdf (Page 29)

2.4 Mounting the ADCU

Mount the ADCU using either of the following options:

Option 1 - Velcro Fastening on a Horizontal Surface

Option 2 - Flush-mounting

The following sections describe how to mount the sensor for both

of these options.

Option 1 - Velcro Fastening on a Horizontal Surface

1. Choose a location based upon the guidelines in

“Choosing the Best Location for the ADCU” on

page 14.

2. Remove the four squares of Velcro fabric from the

kitpack. Clean the bottom of the housing with a

mild detergent and water to remove oils, etc. Peel

the protective backing from the squares and apply

them to the bottom of the housing at each of the

four corners (see Figure 2-16).

3. Position the four Velcro hook disks where the

ADCU will be mounted. Drill screw holes for the

disks and secure in place with the #4-24 screws

supplied in the kitpack.

4. Press the ADCU firmly into place so that the loop

material engages the hook disks.

54-0147

TracVision G4 Technical Manual

When choosing a location, take into

account the space required to

route, position, and strain-relieve all

cables that will be attached to the

back of the ADCU. Directions for

proper wiring are presented in

Section 2.6, “Wiring the ADCU” on

page 29.

Figure 2-16

Mounting the ADCU with

Velcro Attachments

Fabric Strips

Hook Disks

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 154 155

No comments

KVH Industries TracVision G4 User Manual Page 29